Equipment « Power Systems Modeling Laboratory

Home → Equipment

Available Equipment:

Geo 416 Earth ground tester		3- and 4-pole Fall-of-Potential, earth resistance loop testing 4-pole Soil Resistivity testing
TCP303 Probe & TCPA300 Amplifier AC/DC current meter		Development and Analysis Solutions for Designers, Installers, and Service Personnel in Telecomm, Data Comm, Computer, and Semiconductor Power Electronics Environments for: Power Supplies (Switching and Linear) Semiconductor Devices (SCRs, IGBTs, MOSFETs, CMOS, BJTs) Power Inverters/Converters Electronic Ballasts Industrial/Consumer Electronics Mobile Communications (Phone, Satellite, Relay Stations) Motor Drives Transportation Systems (Electronic Vehicles, Electric Trains, Locomotives, Avionics)
C.A 6117 Multi-function installation tester		The high-performance C.A 6117 offers excellent measurement stability, even in disturbed industrial environments. All the measurements needed to test an electrical installation are available: continuity, resistance, insulation, earth and selective earth, loop impedances, type A and AC RCDs. The C.A 6117 can also be used to measure voltage, frequency, current via a clamp, active power, harmonics and phase rotation.
Tektronix DPO2012B 100 MHz, 2-Channel, 1GS/s Digital Phosphor Oscilloscope		100 MHz bandwidth 2 analog channels 1 GS/s sample rate (on all channels) 1 Megapoint record length (on all channels) 5,000 wfm/s maximum waveform capture rate Suite of advanced triggers Wave inspector controls provide easy navigation and automated search of waveform data Automated serial triggering, decode, and search options for I2C, SPI, CAN, LIN, and RS-232/422/485/UART FilterVu variable low-pass filter allows for removal of unwanted signal noise while simultaneously capturing high-frequency events 29 automated measurements, and FFT analysis for simplified waveform analysis TekVPI Probe Interface supports active, differential, and current probes for automatic scaling and units
P5200A – Oscilloscope Probe, High-Voltage Differential Probe, 50 MHz, 1 kV, 50:1, 500:1		The P5200A can be used with any oscilloscope and enables users to safely make measurements of floating circuits with their oscilloscope grounded. The P5200A Active Differential Probe converts floating signals to low-voltage ground-referenced signals that can be displayed safely and easily on any ground-referenced oscilloscope. Over range Indicator Safety certified Switchable attenuation Switchable bandwidth limit Applications Floating measurements Switching power supply design Motor drive design Electronic ballast design CRT display design Power converter design and service Power device evaluation
TMDP0200 – Oscilloscope Probe, High-Voltage Differential Probe, 200 MHz, 6 kV, 50:1, 500:1		Key performance specifications Bandwidths up to 200 MHz Up to 6000 V differential (DC + pk AC) Up to 2300 V common (RMS) Key features Overrange Indicator Safety Certified Switchable Attenuation Switchable bandwidth limit
3390 Arbitrary Waveform Generator, 1µHz to 10MHz		The Model 3390 Arbitrary Waveform/Function Generator provides both a full set of standard waveforms and custom waveform generation. The internal arbitrary waveform generator uses 14-bit resolution and a 125MSamples/second sampling rate to enable the creation of any type of waveform. The waveform can consist of up to 256k points. Up to four user-defined waveforms can be stored in the onboard non-volatile memory.
Fluke 1625-2 GEO Earth Ground Tester Kit		The Fluke 1625-2 is a unique earth ground tester that can perform all four types of earth ground measurement: 3- and 4-Pole Fall-of-Potential (using stakes) 4-Pole Soil Resistivity testing (using stakes)